Defining a cleaning slot

Before submitting a cleaning job, you must define a cleaning slot that contains the cleaning tape.

Make sure that the cleaning tape is located in the slot that you defined as the cleaning slot. After defining the cleaning slot, you can set up a cleaning job for the robotic library drive.

See Creating a cleaning job.

Defined cleaning slots are not inventoried when an inventory job runs.

To define a cleaning slot

  1. On the navigation bar, click Devices.

  2. Click the drive or robotic library for which you are setting up the cleaning.

  3. Select the slot that contains the cleaning tape.

  4. Under General Tasks in the task bar, select Properties.

  5. Check Cleaning slot, and then click OK.

Defining a cleaning slot